1·The first set is blanking and punching compound die.
第一组是消隐和冲压复合模。
2·The structure and machining process of plane diffluent compound die are introduced.
介绍了平面分流组合模的结构和加工工艺。
3·The design describes the structure of compound die stamping flip-chip design and working process.
本次设计阐述了冲压倒装复合模的结构设计以及工作过程。
4·In addition, both the working process of compound die and questions required attention are stated.
同时也阐述了复合模工作过程及注意事项。
5·Analyzed press technology characteristics of vent-windows of the car side board, designed a lancing-drawing compound die.
分析了车厢侧板零件通风窗冲压加工的工艺特点，设计了一副针对该零件加工的切口拉伸复合模。
6·Adopting once punching process and using fewer cost and worse plasticity leftover material finish twice drawing of compound die.
分析了小圆角圆筒件的成形工艺性，利用成本较低、塑性较差的角料，采用一次冲压工序完成二次拉伸的复合模。
7·Besides using nitrogen spring is discussed. I give another resolving method in improving the plane tolerance of compound die part.
并且对氮气弹簧的应用进行了论述，对满足多工位级进模中零件的平面度要求提出了另一种解决方法。
8·Through the analysis of forming technology of regulator of left chair, the method of using two sets of compound die is put forward.
通过对左座椅调整器的成形性工艺分析，提出了采用两套复合模结构的方法，并介绍了模具的具体结构及模具工作过程。
9·The application of the Shared plate technology effectively lowered the cost of the compound die and shortened the manufacturing cycle.
共用模板技术的应用，有效地降低了复合模成本并缩短了制造周期。
10·Improved properly such mechanisms as the location, stripping and scraps treatment, the common compound die was satisfied the need of the automatic stamping.
对普通复合模的定位、卸料以及废料处理等装置加以适当改进，满足了自动冲压的需要。